Description

Glass tube with connection at both ends and SMD2835 light source. Its direct connection to the network allows to eliminate the residual consumption of ballasts and primers, allowing greater durability and less maintenance, instantaneous ignition and the absence of the flicker effect (blinking of the light). No noise.

It has a high efficiency (160 Lm/W) consuming 18W through SMD2835 type LEDs managing to provide a luminous flux of 2880Lm distributed uniformly through an opal glass diffuser from which a color rendering index of 80 is obtained. Its consumption represents a value of 18kWh/1000h, reducing the amount of energy billed and the emissions of polluting gases into the atmosphere.

It has an IP20 degree of protection (valid for dust and humidity indoors), as well as being robust enough for the required mechanical demands. This tube is available in cold white (6000°K). The indicated color temperature may suffer fluctuations corresponding to a tolerance of 7%.

Installation instructions for led tubes:

• Step 1: Disconnect power.
• Step 2: Remove conventional fluorescent tube.
• Step 3: Unscrew and remove primer, then disconnect wires from ballast.
• Step 4: Connect the phase to one end of the tube and the neutral to the other end of the tube.
• Step 5: Place the new led tube and connect the electrical current. ul>

In what places is it convenient to install LED tubes?

Led Tubes are normally installed in places with many hours of lighting: Parking lighting, Street lighting, hotels, university and college lighting, office lighting, shopping center lighting.

For long periods of lighting, it is recommended to use LED tubes with an aluminum body as they dissipate much better heat.