Description

T8 glass LED tube with connection at one end and SMD2835 light source. Its direct connection to the network allows to eliminate the residual consumption of ballasts and primers, allowing greater durability and less maintenance, instantaneous ignition and the absence of the flicker effect (blinking of the light). No noise.

It has a high efficiency (140 Lm/W) consuming 9W through SMD2835 type LEDs, managing to provide a luminous flux of 1260Lm evenly distributed through an opal glass diffuser from which a color rendering index of 80 is obtained. Its consumption represents a value of 9kWh/1000h, reducing the amount of energy billed and emissions of polluting gases into the atmosphere.

It has an IP25 degree of protection (valid for dust and humidity indoors), as well as being robust enough for the required mechanical demands.

LED Tube Installation Instructions:

• Step 1: Disconnect power.
• Step 2: Remove conventional fluorescent tube.
• Step 3: Unscrew and remove the primer, then disconnect the wires from the ballast.
• Step 4: Connect the hot and neutral to an e end of the tube.
• Step 5: Place the new LED tube and connect the electrical current.

Where is it convenient to install LED tubes?< /strong>

Led Tubes are normally installed in places with many lighting hours: Parking lighting, Hotel lighting, University and College lighting, Office lighting, Shopping center lighting.

For long periods of lighting it is advisable to use LED tubes with an aluminum body since they dissipate heat much better.